TQ 2S balance/charge adapter designed for 2S Li-Poly hard packs that use 4mm bullets for power and a 2mm bullets for balance. The 7” (180mm) adapter is constructed using 13 gauge wire with bullet connectors for the battery and a female plug to attach to your charge lead. The XH balance connector is plugged into your balancer interface directly or you can use our trick XH Balance Extension Cable (#2201) to give you more room.
TQ Balance extension cables use our flexible triple black 22 gauge cable material to relocate the balance plugs closer to you, making it easier to balance the pack in your car. The cables have either XH connectors (SMC, Orion type) or ThunderPower style plugs on both ends. Most are 600mm in length and plug into the balance board supplied with your charger.
TQ Balance *charger specific* multi-extension cables use our flexible triple black 22 gauge cable material to relocate the balance plugs closer to you, making it easier to balance the pack in your car. These cables are made to plug directly into the balance port of your charger. One end has your charger specific plug and the other end has either an XH connector (SMC, Orion type) or both an XH and Thunderpower battery connector. These cables eliminate the balance board that came with your charger.
NEW ITEM The #2213 SWITCHED balance extension for iChargers (4010,308 & 406) has a switch to change the sensing wires from 1S to 2S.
When using the #2204 & 2208 Hyperion or Hitec X4 balance extension with the new Hyperion HP-EOS0720i SUPER DUO3 charger you need to align the cable's plug with the right side of the charger port.
When using the #2203 & 2207 TP balance extension cable on the new Thunderpower TP820CD make sure the connector on the cable is shifted to the left side of the charger's balance port. The cable was designed to fit the TP610C that has a shorter port.
When using the #2202.1 balance extension for iCharger 4010, 308 & 406 Duo plug the cable into the right side of the charger's balance port. This cable has the battery balance port attached for use with Deans style batteries. This cable can be altered to be used with either 1S or 2S bullet type batteries by cutting off the battery connector and soldering direct to the plugs (instructions are included). Does not include the 2mm bullet.
The #2211 balance extension for iCharger 4010, 308 & 406 Duo plugs directly into the charger's port and is made for bullet type batteries only. The black lead goes to the negative bullet, the included 2mm tube is soldered to the positive bullet or charge lead. This unit provides use for both 1Cell and 2Cell bullet style packs by "swapping" the 2mm color coded bullets on the cable!
#2211 & #2202.1 and #2213 cables now come with a 3-pin plug that requires no cutting to fit in the iCharger 4010, 308 & 406 Duo. When using this updated cable make sure the connector plugs into the right side of the balance port